|
Post by brokennock on Jan 5, 2021 2:15:03 GMT -7
All right. Here’s a picture. You can see the light behind it but I don’t know if that much is normal. If you are loosing powder out of it, it is not normal. There shouldn't be a gap at all, but if you are loosing powder it needs to be addressed. In the meantime, seal the pan with some beeswax/oil lube. I make mine with wax and coconut oil, used to use olive oil. I make two consistencies, a soft one with a shot of Murphy's Oil Soap added for patch and wad lube, and a stiff one without the soap that is very hard but greasy feeling but melts and softens with the warmth of my hands. I keep a small tin of this second one in my shot pouch as an metal protectant. I run a bead of it around my barrel at the front edge of my cow's knee in wet weather, and, I use it to seal the pan once primed and closed in damp weather. Just smear some around the edge after closing the frizzen.
|
|
|
Post by hawkeyes on Jan 5, 2021 5:59:07 GMT -7
I very much see the steel resting on the shoulder of the pan. Looks to me it's preventing the steel from camming forward completely and closing. Flint definitely needs addressed. I'd switch out to an English or French flint that has a shorter cutting surface.
Yet the best way to determine were it's rubbing or contacting is the use of candle soot to black the area.
A properly fitting steel to pan should require nothing to keep the powder fresh. Definitely would get this issue fixed.
|
|